Nec NEAX 2000 IPS Manual do Utilizador descarregar pdf (Página 31)

Chapter 2 System Configuration BUS Cable Connection between IP-PAD and VCT Cards

NEAX 2000 IPS Configuration Guide

NDA-24347, Issue 1

Page 21

BUS Cable Connection between IP-PAD and VCT Cards

Connect the VCTB/VCTA connector on the IP-PAD card and the VCT1A/VCT0A

connector on the VCT card by the IPTRK BUS CA, as shown below.

When two VCT cards are mounted, connect the VCT1B/VCT0B connector on the

VCT card with the VCT1A/VCT0A connector on the next VCT card, one after

another.

Figure 2-11 IP-PAD BUS Cable Connection

Note: The IPTRK BUS CA consists of a set of three identical cables. Make sure to

connect the IP-PAD and VCT cards by using this set of cables, confirming that

connecting location of each cable must be matched in both IP-PAD and VCT

cards, as shown in Figure 2-11.

IPTRK BUS CA

[0.33 ft. (0.1 m)]

Note

To Dterm IP via LAN

To Internet/Intranet via LAN

IPTRK BUS CA

[0.33 ft. (0.1 m)]

Note

VCTB

VCTA

LAN

VCT1B

VCT0B

VCT1A

VCT0A

VCT1B

VCT0B

VCT1A

VCT0A

IP-PAD

VCT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 95 96

Sem comentários

Nec NEAX 2000 IPS Manual do Utilizador Página 31