NEC M260W Manual do Utilizador descarregar pdf (Página 38)

2. Projecting an Image (Basic Operation)

 After Use

Preparation:Makesurethattheprojectoristurnedoff.

1. Unplugthepowercord.

2. Disconnectanyothercables.

• RemovetheUSBmemoryifitisinsertedintotheprojector.

3. Retractadjustabletiltfootifextended.

• Donottouchthelens.

4. Slidethelenscovertotherighttocoverthelens.

Short-throw model (M350XS/M300XS/M260XS/M300WS/

M260WS)

①

Place each catch on the bottom of the lens cap into two grooves of

the projector.

②

Push the top of the lens cap to cover the lens.

5. Puttheprojectorandaccessoriesinthesuppliedsoftcase.

Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from

damage.

Insert the projector with the lens

facing upward

NOTE:

• Whenplacingtheprojectorinthesoftcase,retractthetiltfootandtherearfeet.Failuretodosomaycasedamagetotheprojec-

tor.

• TheM420X,M420XV,M350XS,M300XS,M260XS,M300WS,andM260WSdonotcomewithasoftcase.

CAUTION:

Usecautionwhenputtingtheprojectorinthesoftcaseimmediatelyaftertheprojectorhasbeenoperating.The

projectorcabinetishot.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 154 155

Sem comentários

NEC M260W Manual do Utilizador Página 38