NEC Express5800/R110f-1E Guia de Configuração descarregar pdf (Página 124)

NEC ESMPRO Manager Setup Guide

123

2-(l) NEC ESMPRO Manager cannot display the blade enclosure (chassis) information for this product. The

product does not support it.

2-(m) The power measurement for the server 1 reads a total of the server 1 and the server 2. The power

measurement for the server 2 always reads 0.

2-(n) Please execute "check connection" for the managed component when BMC FW is updated on the

managed component. If "check connection" is not executed, the remote console function may not run

normally.

2-(o) If the managed component is Dual Server System, the power measurement for each server reads a

total of the server 1 and the server 2.

2-(p) Power supply state display is partly different from module POWER lamp on the device. Only DC on

(turn on green lamp) and DC off (turn off green lamp) correspond in NEC ESMPRO Manager.

2-(q) NEC ExpressUpdate Agent cannot be installed on this product. NEC ExpressUpdate of NEC

ESMPRO Manager is not support for the product.

3. About the operation

3-(a) Only one NEC ESMPRO Manager can control this product.

3-(b) Serial Console Redirection and LAN Console Redirection cannot be used concurrently. To use LAN

Console Redirection, disconnect the cable from the serial port 2 on the front panel, or set the

configuration item "Redirection (WAN/Direct)" to "Disabled".

3-(c) If Linux has been installed on this product, be sure to set the BMC configuration item "Redirection

(WAN/Direct)" to "Disabled". If it is enabled, Linux cannot be booted.

3-(d) To use the remote console function on this product, select "Advance" – "Memory Configuration" and

set "Extended Memory Test" to "Disabled" on the BIOS Setup Utility screen.

3-(e) Following function cannot be used for this product in implementation:

- CUI Remote console function

- Remote drive function

- Power control function

- Scheduled running function

3-(f) Please do not change the delay time on the Power Restore Delay function for this product. This

product is turned on after the waiting time ((slot number - 1) * 2sec). If the delay time is changed from

0 sec (the default value), the waiting time is not set correct value.

3-(g) NEC ESMPRO Manager does not change the power restore delay time for this product even if you

order NEC ESMPRO manager to set the delay time. Because the waiting time ((slot number - 1) *

2sec) should be guaranteed before this product is turned on.

EM Card List

NEC ESMPRO Manager can get a blade enclosure information by communication with the following EM

Card in the blade enclosure.

--EM Card [N8405-019A]

--EM Card [N8405-27]

--EM Card [N8405-043]

Power Bay

NEC ESMPRO Manager can manage the following Power Bay remotely.

--EcoPowerGateway [N8142-36F]

Component based on vPro

NEC ESMPRO Manager can manage the following Express5800/Workstation based on the vPro including

the iAMT firmware version 6.0 and later.

--51Mb

--51Mb-S

--51Ea

--53Xg

1 2 ... 119 120 121 122 123 124 125

Comentários a estes Manuais

Sem comentários

NEC Express5800/R110f-1E Guia de Configuração Página 124

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores NEC Express5800/R110f-1E