NEC Display Wall Calibrator Guia do Utilizador descarregar pdf (Página 45)

45 | NEC DISPLAY WALL CALIBRATOR - USER’S GUIDE

Preferences dialog

The Preferences dialog is accessed from the Edit menu, and is divided into 3 different tabs.

The default settings for the entire Preferences can be restored by clicking the Defaults button. This includes any “Don’t

show this again” messages that have been selected.

Preferences dialog - Calibration Sensor tab

Sensor Type - Selects the model of calibration sensor to use, and shows the current model being used.

Auto-Detect - Attempts to detect the selected model of calibration sensor. NEC Display Wall Calibrator will automatically

detect the calibration sensor when the application is started, however if the sensor was not connected at that time, or if

it was being used by another application, then it may be necessary to re-detect it.

Note: If the sensor was not attached when NEC Display Wall Calibrator was launched, then it may be necessary to exit the NEC

Display Wall Calibrator application and launch it again. In some cases it may be necessary to re-connect the USB sensor for

it to be detected.

Model and Serial Number - Shows the model and serial number of the currently selected calibration sensor device.

Sensor compensation for display backlight type - Some calibration sensors need to know the type of backlight

used on the display being measured in order to provide the most accurate measurements. The software can make this

determination automatically, or it can be manually selected to CCFL (Cold-Cathode Fluorescent Lamp) or LED (Light-

Emitting Diode) types.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 91 92

Sem comentários

NEC Display Wall Calibrator Guia do Utilizador Página 45