NEC GammaCompMD QA Manual do Utilizador descarregar pdf (Página 24)

GammaCompMD QA Client User Manual

IMPORTANT NOTES:

・Unlike other sensors, retractable sensor executes calibration automatically when connected

to the system. As long as PIP MODE main screen setting is correctly done, calibration will be

completed properly without showing Sensor Contact Position Guide (Figure 57) or Continue

Operation dialog (Figure 5). If the screen is not correctly set, calibration will stop with an

error message. Please set up PIP MODE correctly again and re-execute the calibration.

・If the buttons of the Sensor Contact Position Guide (Figure 57) or Continue Operation

dialog (Figure 5) are not shown, push the ESC key to cancel the operation.

・When displaying two or more inputs on one screen, it is necessary that both inputs are

connected to the same display controller. Displays cannot be managed properly when each

input is connected to a different display controller.

・When displaying two or more inputs on one screen, please connect the signal cables of

same connector type (Display Port/DVI/HDMI) to the display.

・Any change of Windows display settings or display controller or input or connection of a

different display typically requires an update of configuration settings. In such a case, please

execute “Re-initialization of the Display Configuration” in GammaCompMD QA Client.

・Executing QA Test with PIP MODE equipped displays will always show Continue Operation

dialog (Figure 5) regardless of PIP MODE setting (ON/OFF). If the screen configuration is

correct, press “Continue” to continue your operation.

・If using this function on a display with PIP MODE (PbP), you need to input the appropriate

resolution on the screen to perform correctly the visual test. When you change the

resolution manually, please return to the original settings after the visual test.

・When the display sensor (Front sensor model or Retractable sensor) is used, be sure to set

the both the EXPANSION mode and the PIP MODE to “FULL” in the ON-SCREEN-DISPLAY

(OSD) of the display.

・Please set the PIP MODE not to "Picture in Picture" but to "Picture by Picture".

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 181 182

Sem comentários

NEC GammaCompMD QA Manual do Utilizador Página 24